Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 122
Editing Programs On Line
Chapter 5
5-2
To begin an edit operation on an active or inactive part program:
1.
Press the
{PRGRAM MANAGE}
softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
The control displays the main part program directory screen:
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
SELECTED PROGRAM:
MAIN
DIRECTORY
PAGE
1
OF
1
NAME
SIZE
COMMENT
MAIN
2.3
O12345
14.3
RRR
9.3
THIS IS A TEST PROG
TEST
3.9
4 FILES
120.2
METERS FREE
2.
Select the directory that contains the program to edit. You can select
the main directory or the protectable directory. The control displays
the main directory as the default directory at power-up. You must
select the protectable directory by using the
{CHANGE DIR}
softkey.
The
{CHANGE DIR}
softkey controls access to the protectable part
program directory. This softkey is password protected. You must
have the proper password to access this softkey. See page 5-42 for
additional information on the protectable directory and the
{CHANGE DIR}
softkey.