Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 15)

Chapter
1
1-1
Using This Manual
This chapter describes how to use this manual. Major topics include:
how the manual is written and what fundamentals are presumed to be
understood by the reader
how the manual is organized and what information can be found in it
definitions for certain key terms
We wrote this manual for operators and programmers who use
Allen-Bradley controls. We assume that you are familiar with the basic
operation and programming of a CNC.
This manual has a basic operation section, a programming section and
three appendices:
Chapter 9
How to operate the control
Chapter 10
Chapter 22
How to program the control
Appendix
A
Softkey List
Appendix
B
Error and Operator
Message List
Appendix
C
G-Code List
11963-I
Chapter 2
1.0
Chapter Overview
1.1
Audience
1.2
Manual Design