Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 277
Communications
Chapter 9
9-17
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
3.
Press the {VERIFY PRGRAM} softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
4.
Type program name(s) into the input area (lines 1- 2) in the following
manner. If both programs are resident in control memory, type both
program names, separated by a comma. The order in which these
names are entered is not important.
VERIFY: program name,program name
If one of the programs to verify is on a peripheral device and the
other is resident in control memory, you type the name of the
program resident in the control only.
VERIFY: program name
5.
To verify a part program in memory against a part program stored on
a peripheral device, press the {VERIFY PORT A} or
{VERIFY PORT B} softkey depending on where the peripheral
device is connected.
To verify a part program in memory against another part program in
memory, press the {VERIFY MEMORY} softkey.
(softkey level 3)
VERIFY
PORT A
VERIFY
PORT B
VERIFY
MEMORY