4 entering passwords – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 50
Chapter 2
Operating the Control
2-30
If the
{ACCESS CONTRL}
softkey does not appear on the screen, the
currently active access level is not allowed to use the
{ACCESS CONTRL}
function. Enter a password that has access to
{ACCESS CONTRL}
.
2.
Press the
{ACCESS CONTRL}
softkey. This displays the access control
screen (Figure 2.5).
(softkey level 2)
ACCESS
CONTRL
3.
Press the
{STORE BACKUP}
softkey. This softkey appears in reverse
video and the message “STORING TO BACKUP -- PLEASE WAIT”
appears on the CRT until the control has finished storing the
password list to its backup memory.
(softkey level 3)
UPDATE
& EXIT
01
(NAME)
02
(NAME)
03
(NAME)
04
(NAME)
STORE
BACKUP
UPDATE
& EXIT
05
(NAME)
06
(NAME)
07
(NAME)
08
(NAME)
After storing the password list, the control returns to softkey level 2
and displays the message “STORED PASSWORD LIST TO
BACKUP” on line 2 of the CRT.
When the control is powered-up, the only functions that are available to the
operator are functions that are not protectable and functions that are
assigned to access level 8 (provided that the active level when power was
turned off was not assigned the power-up level feature). To access the
functions that are assigned to a specific access level, you must enter the
password that corresponds to that access level.
2.7.4
Entering Passwords