Coordinate control, 0 chapter overview – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 317
Chapter
11
11-1
Coordinate Control
This chapter describes the control of the coordinate systems on the control.
G words in this chapter are among the first programmed because they
define the coordinate systems of the machine in which axis motion is
programmed.
Topic:
On page:
Machine (Absolute) Coordinate System
11-2
Motion in the Machine Coordinate System (G53)
11-3
Preset Work Coordinate Systems (G54-59.3)
11-4
Altering Work Coordinate Systems (G10L2)
11-8
Work Coordinate System External Offset
11-10
Altering External Offset (G10L2)
11-11
Offsetting the Work Coordinate Systems
11-13
PAL Offsets
11-22
Rotating the Coordinate Systems
11-23
Rotating the Current Work Coordinate System (G68, G69)
11-24
External Part Rotation
11-28
Plane Selection (G17, G18,G19)
11-33
Overtravels and Programmable Zones
11-34
Absolute/Incremental Modes (G90, G91)
11-44
Inch/Metric Modes (G70, G71)
11-45
Radius/Diameter Modes (G07, G08)
11-46
Scaling
11-48
A thorough understanding of this group makes programming easier by
allowing full control of the coordinate systems.
11.0
Chapter Overview