Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 195
Running a Program
Chapter 7
7-7
Figure 7.2
Part Program Directory
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
SELECTED PROGRAM:
MAIN
DIRECTORY
PAGE
1
OF
1
NAME
SIZE
COMMENT
TEST
AE
3.9
O12345
1.3
SUB TEST 1
MAIN
1.3
SHAFT2
1.3
THIS IS A TEST PROGRAM
XXX
1.3
5 FILES
137.8 METERS FREE
Important: Figure 7.2 shows program TEST as active and being
edited. Make sure no part program is currently active. If a part
program is currently active, the control does not allow the selection of
a different part program until the currently active one is deactivated
(see page 7-9 on deactivating a part program).
If you see an:
To the right of the program name, it means that the program is:
A
currently active
E
currently being edited
2.
Select the directory that contains the program to activate. You can
select either the main directory or the protectable directory. The
control displays the main directory as the default directory at
power-up. You must select the protectable directory by using the
{CHANGE DIR}
softkey.
Important: The
{CHANGE DIR}
softkey controls access to the
protectable part program directory. The
{CHANGE DIR}
softkey is
password protected. You must have the proper password to access
this softkey. See page 5-42 for additional information on the
protectable directory and the
{CHANGE DIR}
softkey.