Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 27)

Chapter 2
Operating the Control
2-7
Your control has one of these monitors:
9-inch monochrome monitor
19435
12-inch color monitor
19436
Both have identical displays and graphics capabilities.
Certain lines of the screen are dedicated to displaying specific information:
Line Area Content
1 machine/system
message If an error occurs or a message is generated for any reason during
machine operation or program execution, the control displays the
corresponding machine/system message in this area. Only the
highest priority, most current message is displayed here.
2 - 3 input lines When data is entered using the keyboard, the control displays the
entered characters on these lines until you press the
[TRANSMIT] key. Some screens can have only line 2 as an
input line.
4 - 20 data display The control displays axis position data, listing of the part program,
wheel length offset data, G/M/H/T/F/S/D codes, graphics, and
other data in this area as determined by the selected display.
21 - 22 PAL message The control displays any messages generated by the control’s PAL
program in this area.
23 - 25 softkey display The control displays the currently available softkey functions in this
area.
2.1.3
Using the CRT