Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 101)

Chapter 3
Offset Tables and Setup
3-29
4. Use the up and down cursor keys to move the cursor to the feedrate
you want to change. The selected feedrate appears in reverse video.
5. Change feedrate values by using one of two choices:
(softkey level 4)
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
If you want to: Key in the: Press this softkey:
replace stored feedrate feedrate data new data {REPLCE VALUE}
add to previously stored feedrate data amount to be added {ADD TO VALUE}
6. Leave the feedrate parameter screen by using one of two choices:
(softkey level 4)
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
If you want to: Press this softkey:
save the changes you just made {UPDATE & EXIT}
delete all changes you just made {QUIT}
Tool offset range verification checks:
the maximum values entering the tool offset tables
the maximum change that can occur in either table
To use tool offset range verification, follow this softkey sequence:
1. Press the {SYSTEM SUPORT} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {AMP} softkey.
3.11
Tool Offset Range
Verification