Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 47)

Chapter 2
Operating the Control
2-27
Important: If you want to activate or deactivate a function that is not
accessible to the current user’s access level, the message “ACCESS TO
THIS FUNCTION NOT ALLOWED” appears. Only features that are
accessible to the current user’s access level can be selected as accessible or
inaccessible to a lower user’s access level.
7. Press the {UPDATE & EXIT} softkey to store the changes made to
accessible functions for the user levels and return the control to
softkey level 1.
(softkey level 3)
UPDATE
& EXIT
01
(NAME)
02
(NAME)
03
(NAME)
04
(NAME)
STORE
BACKUP
UPDATE
& EXIT
05
(NAME)
06
(NAME)
07
(NAME)
08
(NAME)
This section describes the functions on the control that can be protected
from an operator by the use of a password. If a user has access to a
function, the parameter associated with that function appears in reverse
video on the access control screen (see Figure 2.5).
You control access to the functions in Table 2.C by using passwords.
Table 2.C describes the function that is enabled (the operator can perform
them) if the parameter name appears in reverse video. If the function does
not appear in reverse video, the function is protected and cannot be
accessed by the operator.
Some parameters enable more than one function. If a parameter that
enables multiple functions is not selected as accessible, some of the
functions that would be enabled by the parameter can be enabled
individually by using other parameters.
2.7.2
Password Protectable
Functions