Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 271
Communications
Chapter 9
9-11
5.
If you have already entered the name in the program, skip step 5. and
go to step 6. Otherwise, enter the program name to copy by either
selecting it using the up and down cursor keys or typing it in by using
the alphanumeric keys on the keyboard. The control displays the
program name on the input line (line 2) of the screen next to the
prompt “SELECTED PROGRAM:”.
If you make an error while typing in the new program name, you can
make corrections on the input line as described on page 2-41.
6.
Select the device to copy from using the following table.
If the peripheral device is connected to:
Press this softkey:
Port A
{FROM A TO MEM}
Port B
{FROM B TO MEM}
The screen is changed to the “COPY PARAMETERS” screen, as
shown in Figure 9.2, that displays the current device and setup
parameters for that communication port.
If the device displayed on the screen is not correct, select the correct
device using the procedure described on page 9-4.
Figure 9.2
Copy Parameter Screen
COPY PARAMETERS
FROM:
(SELECTED PORT NAME)
TO:
(PROGRAM NAME)
DEVICE:
FACIT N4000
BAUD RATE:
2400
PROTOCOL:
LEVEL_2*
OUTPUT CODE:
ASCII
AUTO FILENAME:
NO
STOP PRG END:
YES
PROGRAM END:
M02, M30
M99
SINGLE
PRGRAM
MULTI
PRGRAM
OUTPUT
ALL