The in-process dresser status screen appears – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 717
In-process Dresser
Chapter 21
21-11
2.
Press the {DRESSR TABLE} softkey to display the in-process
dresser status screen.
(softkey level 2)
WORK
CO-ORD
WHEEL
GEOMET
RADIUS
TABLE
DRESSR
TABLE
SCALNG
COORD
ROTATE
BACKUP
OFFSET
The in-process dresser status screen appears:
REPLCE
VALUE
ADD TO
VALUE
INCH/
METRIC
ENTER NEW WHEEL DIAMETER:
IN-PROCESS DRESSER STATUS
[INCH]
DRESSER ACTIVE/INACTIVE
:
INACTIVE
DRESSER HOLD/NOT HOLD
:
NOT HOLD
INITIAL WHEEL DIAMETER
:
0.0000
CURRENT WHEEL DIAMETER
:
0.0000
CURRENT DRESSER RPM
:
0.
*NEW
WHEEL DIAMETER
:
20.0000
*WARNING WHEEL DIAMETER
:
19.0000
*MINIMUM WHEEL DIAMETER
:
18.7500
*MAXIMUM WHEEL SPEED(RPM) :
90000.
*WHEEL WIDTH
:
0.0000
*DRESSER ROLL DIAMETER
:
2.1000
*DRESSER AMOUNT PER REV
:
0.0000140
*DRESSER RETRACT DISTANCE :
0.2000
*DRESSER SURF SPEED RATIO :
0.81
*
only these parameter values can be altered by the operator (asterisk does not appear on screen)
3.
Use the up and down cursor keys to place the cursor on the parameter
you want to modify. The selected parameter appears in reverse video.
Table 21.A describes these parameters.
4.
Select the unit system to be used (inch or metric) by pressing the
{INCH/METRIC} softkey.