Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 37)

BLOCK
RETRCE JOG
RETRCT CYCLE
START CYCLE
STOP
(softkey level 3)
BLOCK
RETRCE JOG
RETRCT CYCLE
START CYCLE
STOP
(softkey level 3)
JOG
AXES+ JOG
AXES-
(softkey level 4)
Chapter 2
Operating the Control
2-17
2. Press the softkey that corresponds to the selected option.
To perform
this operation: Press:
Cycle Start or
Cycle Stop the softkey that corresponds to the desired feature. Details on these
features are described earlier in this chapter.
Block Retrace the {BLOCK RETRCE} softkey; each time you press the {BLOCK
RETRCE} softkey the control automatically retraces the previously
executed block. Pressing {CYCLE START} returns the wheel to the
start point of block retrace. Details on block retrace can be found in
chapter 7.
Jog Retract the {JOG RETRCT} softkey. This calls up the jog retract screen. Select
the axis, type of jog, speed multiply value (see page 4-1 ), and HPG
number (if HPG has been selected as the type of jog) by using the up
and down cursor keys to select the function, and the left and right cursor
keys to alter the value assigned to that function.
the {JOG AXES+} or {JOG AXES--} softkeys to select the direction to jog
the axis. Press the exit {
↑
} softkey when the jog retract is complete.
The grinding wheel automatically retraces the jog moves made when
the {CYCLE START} softkey is pressed. Details on jog retract can be
found in chapter 7.