Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 161)

Editing Programs On Line
Chapter 5
5-41
If a comment has previously been entered, it is displayed to the right
of the “COMMENT” prompt. This comment can be edited using the
input cursor as covered on page 2-41, or the old comment can be
deleted by pressing the
[DEL] key while holding down the [SHIFT]
key.
4. Type in the new comment or edit the old comment by using the
keyboard keys.
5. When the new comment is correctly displayed on line 2 of the screen,
press the
[TRANSMIT] key. The new comment is displayed next to the
selected program.
This section contains information on making a duplicate of an existing part
program in the control’s memory. To input or output a part program
from/to a peripheral device, see the sections on inputting or outputting
programs covered in chapter 9.
To copy part programs stored in memory using different program names:
1. Press the {PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {COPY PRGRAM} softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
3. Key in or cursor down to the program name of the program you want
to copy.
5.9
Copying Programs
{COPY PRGRAM}