Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 182)

Editing Part Programs Off Line
Chapter 6
6-12
The programmer can upload a part program from the control’s memory to
the workstation using the Upload application of ODS. This allows the part
program to be edited or stored on the workstation.
Important: Part programs in the protectable program directory may be
encrypted when they are uploaded from the control to ODS. If a protected
part program is encrypted, it can be opened through the Part Program
application of ODS, but it is unreadable because it was encrypted during
the upload. See page 5-42 for additional information on the protectable
part program directory and program encryption.
1. Interface the workstation with the control. See page 6-5.
2. Return to the main menu line of ODS.
3. Press
[F3]
to pull down the Application menu.
The workstation displays this screen:
F1 - File F2 - Project F3 - Application F4 - Utility F5 - Configuration
Proj: PALTEST Appl: Upload Util: Get PAL I/O
AMP
PAL
I/O Assignments
Part Program
Upload
Download (A)
(P)
(I)
(R)
(U)
(D)
4. Use the arrow keys to highlight the Upload application then press
[ENTER], or press [U].
6.5
Uploading Part Programs to
ODS