Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 63)

Chapter 2
Operating the Control
2-43
2. Press the {REFORM MEMORY} softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
DELETE
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
3. Press the {REFORM YES} softkey. All programs that are stored in
control memory are deleted.
(softkey level 3)
REFORM
NO
REFORM
YES
It can take several seconds for the control to complete the operation.
During this period, the softkeys on the operator panel are “disabled”
until the format operation is completed.
To abort the operation, press the {REFORM NO} softkey.
(softkey level 3)
REFORM
YES
REFORM
NO
Use the axis detach feature to remove (detach) a rotary table or other axis
attachment from a machine. When activated, the control ignores messages,
e.g., servo errors, that occur resulting from the loss of feedback from a
detached axis.
Important: The axis detach feature removes the selected axis from the
control as an active axis. Any attempt to move the detached axis results in
an error. This means that part programs that use the detached axis name
cannot be executed. Jog moves and MDI commands that attempt to move
the detached axis also result in an error.
You enable this feature in AMP. You must select the axis as “detached” to
be considered removed. See the documentation supplied by your system
installer for the steps involved in detaching an axis or physically removing
axis hardware from your machine.
2.13
Removing an Axis
(Axis Detach)