Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 145)

Editing Programs On Line
Chapter 5
5-25
Grinder cycle prompting aids the operator in programming surface or
cylindrical grinding cycle blocks by prompting the programmer for the
necessary parameters and giving a graphical representation of the cycle
operation.
For G-code prompts other than these cycles, see page 5-23.
To use the grinder cycle prompting function, follow these steps:
1. From the QuickView menu, press the {GRINDR PROMPT} softkey.
QPATH+
PROMPT
G CODE
PROMPT
GRINDR
PROMPT
PLANE
SELECT
(softkey level 4)
One of the following two screens appear depending on your control
type configuration in AMP.
If you have configured a cylindrical grinder, this screen appears:
SELECT
E-STOP
GRINDER PROMPT MENU DISPLAY
.
G80 CANCEL OR END FIXED CYCLE
G81 RECIPROCATION
G81.1 RECIPROCATION PREDRESS
G82 INCREMENTAL FACE
G82.1 INCREMENTAL FACE PREDRESS
G83 INCREMENTAL PLUNGE
G83.1 INCREMENTAL PLUNGE PREDRESS
G84 MULTI FACE
G84.1 MULTI FACE PREDRESS
G85 MULTI PLUNGE
G85.1 MULTI PLUNGE PREDRESS
G86 SHOULDER
G86.1 SHOULDER PREDRESS
G87 FACE PLUNGE SHOULDER
G87.1 FACE PLUNGE SHOULDER PREDRESS
G88 DIAMETER PLUNGE SHOULDER
G88.1 DIAMETER PLUNGE SHOULDER PREDRESS
5.3.3
Grinding Cycle Prompting
{GRINDR PROMPT}