Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 661)

Paramacros
Chapter 20
20-17
5500 to 5509 In-Process Dresser Parameters 20-32
5600 to 5625 Part Program Block Create through PAL Display Pages 20-33
Table 20.D
System Parameters (continued)
Parameter # System Parameter Page
5630 1 S--Curve Time per Block 20-33
5661 to 5642 1 Acceleration Ramps for Linear Acc/Dec Mode 20-34
5651 to 5662 1 Deceleration Ramps for Linear Acc/Dec Mode 20-34
5671 to 5682 1 Acceleration Ramps for S--Curve Acc/Dec Mode 20-35
5691 to 5702 1 Deceleration Ramps for S--Curve Acc/Dec Mode 20-35
5711 to 5722 1 Jerk 20-36
5731 to 5743 Home Marker Distance 20-36
5751 to 5763 Home Marker Tolerance 20-37
1 These parameters may only have their value received (read-only)
2 These parameters may only have their value changed (write-only)
Pages 20-18 through 20-33 contain descriptions of the system variables.
Important: Angled wheel grinders that have a virtual axis can access
system parameters for the virtual axis. The virtual axis is the non-physical
axis created by the control that is perpendicular to the part spindle
centerline. This virtual axis is assigned system paramacro parameters as
the last axis number after the last real axis (excluding non-positioning
spindles). For example if your angled wheel grinder has two linear axes, a
rotary axis that controls the wheel angle, a non positioning part spindle,
and a wheel spindle, then system parameters for axis four represent the
status of the virtual axis.