Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 184
Editing Part Programs Off Line
Chapter 6
6-14
7.
Use the arrow keys to highlight the upload origin then press
[ENTER]
or press the letter that corresponds to the upload origin.
The workstation displays the part program files that are stored on the
control or storage device:
F1 - File
F2 - Project
F3 - Application
F4 - Utility
F5 - Configuration
Proj: Demo
Appl: Part Program
Util: Get Part Program
FILE1 FILE2 FILE3
Upload From...
Use ARROW keys or Type in name.
Press ENTER when done, or ESC to cancel.
8.
Use the arrow keys to highlight the name of the part program to be
uploaded to the workstation or type in the part program name, then
press
[ENTER]
.
Important: You can upload more than one part program using
wildcards (“*” or “?”) in place of all or part of a file name.
See the workstation’s DOS manual for additional information on
using wildcards.