Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 81)

Chapter 3
Offset Tables and Setup
3-9
Figure 3.7 shows the possible dresser orientations relative to the grinding
wheel.
Figure 3.7
Dresser Orientations
1
6
2
4
3
8
7
5
0 or 9
11988-I
The control uses the value selected for orientation to determine the
orientation of the dresser when dresser/wheel radius compensation is
active. Enter the proper dresser orientation number (0-9) in the radius
offset table for the ORNT parameters. From that information, the control
can keep track of the orientation of the dresser you are currently using and
prevent some programming errors. Details on entering this information in
the actual offset table are covered on page 3-11.
3.3.1
Dresser Orientations