Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 157)

Editing Programs On Line
Chapter 5
5-37
To delete a part program stored in memory:
1. Press the {PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {DELETE PRGRAM} softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
ATTENTION: Once you delete a program from memory, it
cannot be recovered. To abort the delete program operation,
press the
{DELETE NO} softkey.
3. Select one of these two choices:
Key in the program name and press the {DELETE YES} softkey
Move the block cursor down until the desired program is in reverse
video and press the
{DELETE YES} softkey
DELETE
YES
DELETE
NO
(softkey level 3)
You can delete all programs at once by formatting the RAM disk as
described on page 2-42. Formatting the RAM disk, however, deletes all
programs from both the main directory and the protected directory. If you
do not have access to the protected directory, do not format the RAM disk.
5.5
Deleting A Program
{DELETE PRGRAM}