2 running graphics – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 245
Displays and Graphics
Chapter 8
8-25
2.
Select a program. Press
{SELECT PRGRAM}
.
(softkey level 2)
SELECT
PRGRAM
QUICK
CHECK
STOP
CHECK
T PATH
GRAPH
T PATH
DISABL
3.
Use the up and down cursors to select a program.
4.
Press
{ACTIVE PRGRAM}
to return to level 2 and activate the program.
Follow these steps to run graphics:
1.
Press the
{PRGRAM CHECK}
softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2.
Select a program. Press
{SELECT PRGRAM}
.
(softkey level 2)
SELECT
PRGRAM
QUICK
CHECK
STOP
CHECK
T PATH
GRAPH
T PATH
DISABL
3.
Use the up and down cursors to select a program.
4.
Select graphics. Follow the appropriate steps:
(softkey level 2)
SELECT
PRGRAM
QUICK
CHECK
STOP
CHECK
T PATH
GRAPH
T PATH
DISABL
SELECT
PRGRAM
QUICK
CHECK
STOP
CHECK
T PATH
GRAPH
T PATH
DISABL
(softkey level 2)
Active Graphics
QuickCheck Graphics
GRAPH
SYNTAX
ONLY
(softkey level 3)
The graphics you select remains active until you disable graphics.
5.
Press the <CYCLE START> button to plot the part program.
8.4.2
Running Graphics