Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 29)

Chapter 2
Operating the Control
2-9
Table 2.B
Selections on the MTB Panel and How They Work
Switch or Button Name How It Works = Default for Push-Button MTB Panel
MODE SELECT Selects the operation mode
AUTO -- -- automatic mode
MANUAL -- -- manual mode
MDI -- -- manual data input mode
JOG SELECT Selects the jog method to be active in manual mode
HANDWHEEL -- -- HPG (hand pulse generator) jog
INCREMENTAL -- -- incremental jog
CONTINUOUS -- -- continuous jog
HOME -- -- machine home
SPEED/MULTIPLY Selects an axis feedrate or axis feed amount multiplication ratio used in the manual mode. Each
selection modifies the active feedrate by a value set in AMP. Modification also depends on the setting
of <JOG SELECT> as described below:
• HANDWHEEL
When in handwheel jog mode, SPEED/MULTIPLY alters the handwheel resolution by a factor
determined in AMP. Your system installer sets the value for:
- LOW X1
- MEDL X10
- MEDL X100
You cannot use the values listed below for handwheel jog:
- MEDH X1000
- HIGH X10000
• INCREMENTAL
When in incremental jog mode, SPEED/MULTIPLY alters the incremental jog distance by a factor set
in AMP by your system installer. Your system installer sets a value for the selections. The
incremental jog speed is fixed to medium but can still be controlled by
<FEEDRATE OVERRIDE>.
• CONTINUOUS
When in continuous jog mode, SPEED/MULTIPLY acts as a feedrate selection switch which has
values set in AMP by your system installer. Your system installer sets a value for all 5 selections
independently for each axis. <FEEDRATE OVERRIDE> can be used for speed adjustments.
Important: The values for the different <SPEED/MULTIPLY> selections are configured by your
system installer.