Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 667)

Paramacros
Chapter 20
20-23
Table 20.G
Modal Data Parameters
Parameter Number Modal Data Value
#4001 to 4021 G-code Groups 1-21 (see page 20-54) and list what G-code from
which group is currently active.
4108 Current E word value
4109 Current F word value
4113 Most recently programmed M-code
4114 Most recently programmed N word
4115 Current program number O word
4119 Current S word value
4120 Current T word value
For example, if currently programming in G02 mode at a feedrate of 100,
the parameters are as follows:
G02 is in G-code group 1, so parameter #4001 is set to 02
the programmed feedrate is F100, so parameter #4109 is set to 100
#5001 to 5012
Coordinates of End Point
These parameters are read-only. They correspond to the coordinates of the
end point (destination) of a programmed move. These are the coordinates
in the work coordinate system.
5001 Axis 1 coordinate position 5007 Axis 7 coordinate position
5002 Axis 2 coordinate position 5008 Axis 8 coordinate position
5003 Axis 3 coordinate position 5009 Axis 9 coordinate position
5004 Axis 4 coordinate position 5010 Axis 10 coordinate position
5005 Axis 5 coordinate position 5011 Axis 11 coordinate position
5006 Axis 6 coordinate position 5012 Axis 12 coordinate position
The system installer determines in AMP the name (or word) that is used to
define the axis.