Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 814)

9/Series Grinder
Index
Operation and Programming Manual
x
Program Position Display, 8-3
Program Search, {SEARCH}, 7-10
Programmable Acc/Dec, 12-67
Programmable Zones, 3-25, 11-34, 11-35
on an angled-wheel grinder, 14-17
zone 2, 11-35, 11-38
zone 3, 11-35, 11-40
Programming Configuration, 10-6
Prompting
G Codes, 5-23
grinder cycles, 5-17
grinding fixed cycles, 5-25
QuickPath Plus, 5-19
Protectable Directory
downloading to, 6-6
protected program encryption/decryption, 5-45
storing encryption/decryption table to backup
memory, 5-48
uploading from, 6-12
PTO Message, 8-37
Q
QPP, 12-11
Quick Check , {QUICK CHECK}, Changing Quick Check
with Graphics, 8-24
QuickCheck, Softkey, 7-18
QuickPath Plus, 12-11
circular, 12-17
linear, 12-13
prompting patterns, 5-19
QuickView, 5-16
on an angled-wheel grinder, 14-6
plane selection, 5-27
R
Radius
dresser, 3-6
offsets, 3-4
wheel, 3-7
wheel corner, 3-6
Radius Mode (G07), 11-46
Radius Offset Table, 3-11
Radius offsets for in process dresser, 21-6
RAM Disk, 2-42
Rapid Feedrate, 12-57
Rapid Feedrate Override, 2-10, 12-58
Rapid Positioning Mode (G00), 12-2
Rapid Traverse, 8-29
Reciprocation, 16-4, 16-13, 17-5, 17-11
cancel, 16-8, 17-8
primary reversal point, 16-8, 17-14, 17-18
secondary reversal point, 16-9, 17-14, 17-18
Reform Memory, 2-42
Removing an axis, 2-43, 4-10
Renaming Programs, 5-38
Retrace, block, 2-10
Reversal Point
primary, 16-8, 17-14, 17-18
secondary, 16-9, 17-14, 17-18
Ricoh PTR240R, 9-4
Rotary Axes, 12-9
feedrates, 12-60
rollover, 12-9
Rotary Axis, homing, 4-11
Rotating Coordinate System
external, 11-28
programmed, 11-23
Rough Facing Cycle (G24), 18-7
RPM Spindle Speed Mode, 12-34, 12-51
RPM, maximum wheel speed, 21-9
S
S Word, 10-35, 12-34, 12-42, 12-52
S--Curve Acc/Dec, 12-66
Save CRT, 8-39
Saving programs, 5-15
Scaling
activating (G14.1), 11-48
cancelling (G14), 11-48
display screen, 11-51
magnification data screen, 11-52
restrictions, 11-54
Screen Saver, 8-39
Screens, Custom through PAL, 8-22
Search
moving the cursor, 5-5
program search, 7-10
search with recall, 7-13
Select Graph, 8-29