Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 86)

Chapter 3
Offset Tables and Setup
3-14
5. Offset data can be replaced or added to:
If you want to: Key in the: Press this softkey:
replace stored offset data with new data new data {REPLCE VALUE}
add to previously stored offset data amount to be added {ADD TO VALUE}
You can copy length offset data from one axis to another axis for all
offset numbers (rather than having to change each axis individually).
a. Press the {COPY OFFSET} softkey.
“COPY (SOURCE, DESTINATION) :” appears.
b. Enter the axis letter from which the data is coming, then a
comma, and then enter the axis letter to which the data is going.
For example:
COPY (SOURCE, DESTINATION): X1,X2
copies the offset data from the X1-axis to the X2-axis for all
offset numbers.
(softkey level 3)
SEARCH
NUMBER
REPLCE
VALUE
ADD TO
VALUE
ACTIVE
OFFSET
MORE
OFFSET
MEAS-
URE
INCH/
METRIC
COPY
OFFSET
RADI/
DIAM