Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 49)

Chapter 2
Operating the Control
2-29
Table 2.C
Password Protectable Functions (continued)
Parameter Name Function becomes accessible when parameter name appears in reverse video:
15) PRGRAM
PARAMETERS {PRGRAM PARAM} — Display and change the tables for programmable zones 1 and 2, the single digit
feedrates, and the fixed cycle operating parameters.
16) ONLINE AMP {AMP} — Display and change the online adjustable machine parameters.
17) PARAMACRO
™
PARAM {MACRO PARAM} — Display or change any of the values in the paramacro tables without using
programming commands.
18) ACCESS CONTROL {ACCESS CONTRL} — Assign different functions to different access levels, change the current
password, or view the functions assigned to the different access levels.
19) SWITCH LANGUAGE {SWITCH LANG.} — Change the current displays from one language to another.
20) POWER-UP LEVEL When POWER-UP LEVEL is shown in reverse video, it indicates that if power is turned off when this level
is active, this level automatically becomes active when power is turned back on. If this is not in reverse
video, it indicates that the control defaults to level 8 access control at next power-up.
21) TIME PARTS • {SET TIME} — Change or reset time parameters
• {SET DATE} — Change or reset date parameters
When TIME PARTS is not in reverse video, the operator can only perform the following functions on the
time and parts screen: RUN TIME, CYCLE TIME, and LOT SIZE.
22) SI/OEM MESSAGE • {ENTER MESSAGE} — Enter a new message to be displayed on the control’s power-up screen.
• {STORE BACKUP} — Store an entered message for the power-up screen to Backup memory.
23) SCALING When SCALING is not in reverse video, the operator still has access to the {SCALNG} softkey; however
values on the screen cannot be modified.
24) CHANGE DIRECTORY {CHANGE DIR} — Display either the main part program directory or the protectable part program directory.
25) AUX COMM Allows access to the {AUX COMM} softkey that sets Data Highway Communication Module Parameters.
26) SEARCH MONITOR Allows access to the {SEARCH MONITOR} softkey that allows searching and monitoring of the control’s
PAL program.
27) PASS THRU ENABLE Allows access to the {PT ENABLE} softkey that enables remote I/O pass thru of AMP, PAL, and other ODS
features. The {PT ENABLE} softkey is only available when AMP is configured to disallow block transfers
and the system contains remote I/O hardware that has been enabled through PAL.
You can save your password list in the backup memory of the control so
that it won’t be lost if system power and battery-backup fails.
To store the password list, follow these steps:
1. Press the {PASSWORD} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2.7.3
Storing Password List to
Backup Memory