Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 678)

Paramacros
Chapter 20
20-34
#5631 to 5642
Acceleration Ramps for Linear Acc/Dec Mode
These parameters are read only. They correspond to the active acceleration
ramps in Linear Acc/Dec mode. You can set these parameters by
programming a G48.1 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5631 Axis 1 acceleration ramp 5637 Axis 7 acceleration ramp
5632 Axis 2 acceleration ramp 5638 Axis 8 acceleration ramp
5633 Axis 3 acceleration ramp 5639 Axis 9 acceleration ramp
5634 Axis 4 acceleration ramp 5640 Axis 10 acceleration ramp
5635 Axis 5 acceleration ramp 5641 Axis 11 acceleration ramp
5636 Axis 6 acceleration ramp 5642 Axis 12 acceleration ramp
#5651 to 5662
Deceleration Ramps for Linear Acc/Dec Mode
These parameters are read only. They correspond to the active deceleration
ramps in Linear Acc/Dec mode. You can set these parameters by
programming a G48.2 in your part program block. Control Reset, Program
End (M02/M03), or G48 will reset these values to their default AMP values.
For more information about programming G48.x codes, refer to chapter 18 in
your 9/Series CNC Operation and Programming Manual.
5651 Axis 1 deceleration ramp 5657 Axis 7 deceleration ramp
5652 Axis 2 deceleration ramp 5658 Axis 8 deceleration ramp
5653 Axis 3 deceleration ramp 5659 Axis 9 deceleration ramp
5654 Axis 4 deceleration ramp 5660 Axis 10 deceleration ramp
5655 Axis 5 deceleration ramp 5661 Axis 11 deceleration ramp
5656 Axis 6 deceleration ramp 5662 Axis 12 deceleration ramp