Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 372)

Coordinate Control
Chapter 11
11-56
G33
G33 Z_F_E_Q
G33 X_Z_F_E_Q
G33 X_F_E_Q
X (scaled)
Z (scaled)
E (not scaled)
F (not scaled)
Q (not scaled)
G34
G34 Z_F_E_Q K
G34 X_Z_F_E_Q K
G34 X_F_E_Q K
X (scaled)
Z (scaled)
E (not scaled)
F (not scaled)
Q (not scaled)
K (scaled)
G20
G20 X_Z_I_
X (scaled)
Z (scaled)
I (scaled)
ATTENTION: This cycle cuts more metal when scaling is
enabled.
G24
G24 X_Z_K_
X (scaled)
Z (scaled)
K (scaled)
ATTENTION: This cycle cuts more metal when scaling is
enabled.
END OF CHAPTER