Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 262)

Communications
Chapter 9
9-2
2. Press the {DEVICE SETUP} softkey to display the device setup
screen as shown in Figure 9.1.
(softkey level 2)
PRGRAM
PARAM
AMP DEVICE
SETUP
MONI-
TOR
TIME
PARTS
PTOM
SI/OEM
SYSTEM
TIMING
Figure 9.1
Device Setup Screen
E-STOP
SERIAL PORT: A
DEVICE: DECITEK AB 8000-XPDR
PORT TYPE: RS232
BAUD RATE: 1200
PROTOCOL: LEVEL 2*
PARITY: EVEN
STOP BITS: 1
DATA LENGTH: 8
TIMEOUT: 15 SEC
OUTPUT CODE: N/A
AUTO FILENAME: NO
STOP PRG END:
YES
PROGRAM END: M02, M30: YES
M99: YES
%: NO
PRGRM NAME: YES
SAVE
CHANGE
COPY
DEFLTS
Important: Figure 9.1 displays a typical tape device setup screen. AUTO
FILENAME, STOP PRG END, and PROGRAM END are available only if
you have selected a tape reader or tape punch as your device. See page
9-4 on selecting a device.