Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 804)

G-Code Table
Appendix C
C-4
Surface
Grinder Cylindrical
Grinder
Group
Number
Function Modal or
Non-modal
G82.1 Plunge grind with predress
-- -- G82.1 Incremental face grind with predress, axis 1 plunge
G83 -- -- Incremental plane grind, axis 1 plunge
-- -- G83 Incremental plunge grind, axis 2 plunge
G83.1 -- -- Incremental plane grind, axis 1 plunge with predress
-- -- G83.1 Incremental plunge grind, axis 2 plunge with predress
G84 -- -- Incremental plane grind, axis 2 plunge
-- -- G84 Multi-pass face cycle
G84.1 Incremental plane grind, axis 2 plunge with predress
-- -- G84.1 Multi-pass face cycle with predress
G85 -- -- Continuous plane grind, axis 1 plunge
-- -- G85 09 Multi-pass diameter plunge Modal
G85.1 -- -- Continuous plane grind, axis 1 plunge with predress
-- -- G85.1 Multi-pass diameter plunge with predress
G86 -- -- Continuous plane grind, axis 2 plunge
-- -- G86 Shoulder grind cycle
G86.1 Continuous plane grind, axis 2 plunge with predress
-- -- G86.1 Shoulder grinder cycle with predress
-- -- G87 Face plunge shoulder cycle
-- -- G87.1 Face plunge shoulder cycle with predress
-- -- G88 Diameter plunge shoulder cycle
-- -- G88.1 Diameter plunge shoulder cycle with predress
G90 G90 03 Absolute mode
G91 G91 Incremental mode
G92 G92 00 Maximum CSS spindle RPM, coordinate offset Non-modal
G92.1 G92.1 Cancel offsets
G92.2 G92.2 Cancel select offsets and G92 presets
G93 G93 05 Inverse time feedrate mode Modal
G94 G94 Feed per minute feedrate mode
G95 G95 Feed per revolution feedrate mode
G96 G96 17 Constant surface speed on
G97 G97 RPM spindle speed mode (CSS off)
END OF APPENDIX