Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 28)

Chapter 2
Operating the Control
2-8
Figure 2.4 shows the MTB panel. Table 2.B lists the selections on this
panel. Your system may contain optional or custom MTB panels different
than the one shown below. See the documentation prepared by your
system installer for details.
We show selection names on the MTB panel between the < > symbols
when referred to in this manual. Most selections on the MTB panel are
configured by your system installer’s PAL program. This manual assumes
that PAL has been written as intended for normal operation. If a selection
does not work the way it is described in this manual, see documentation
prepared by your system installer.
Figure 2.4
Push-Button MTB Panel
JOG SELECT SPINDLE SPEED
OVERRIDE
SPINDLE
DIRECTION
MODE SELECT SPEED/MULTIPLY
FEEDRATE
OVERRIDE RAPID FEEDRATE
OVERRIDE
0 150
50 100
EMERGENCY
STOP
AUTO MDI MAN
INCR CONT
HAND HOME
CYCLE
START
SINGLE
BLOCK
CYCLE
STOP
+X +4 --X
+Y TRVRS --Y
+Z --4 --Z
F1 F2
F3 F4
F5 F6
CCW CW
OFF
F1 25
50 100
LOW
X1 MEDL
X10 MED
X100
MEDH
X1000 HIGH
X10000
%
ESTOP
RESET
OFF
ON
AXIS FUNCTION
2.2
The MTB Panel