Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 276)

Communications
Chapter 9
9-16
(softkey level 3)
SINGLE
PRGRAM
MULTI
PRGRAM
OUTPUT
ALL
Figure 9.4
Copy Parameters Screen
COPY PARAMETERS
FROM: (Program Name)
TO: (Selected Port Name)
DEVICE: FACIT N4000
BAUD RATE: 2400
PROTOCOL: LEVEL_2*
OUTPUT CODE: ASCII
AUTO FILENAME: NO
STOP PRG END: YES
PROGRAM END: M02, M30
M99
CANCEL
Important: Press {CANCEL} to abort the copy operation at any time.
To verify that a part program stored in memory matches a source program
stored in memory or on a peripheral device:
1. If one of the programs to either verify or verify against is on a
peripheral device, make sure that the peripheral device is connected
to the correct serial port and that the port is configured for that device
(see page 9-4).
2. Press the {PRGRAM MANAGE} softkey.
9.4
Verifying Part Programs
Against Source Programs