Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 176)

Editing Part Programs Off Line
Chapter 6
6-6
If the serial communication parameters of port B do not correspond to the
serial communication parameters of the workstation, see your
programming manual.
After using the part program edit utility to create or edit a part program file
off line, the programmer can download this part program to the control or
to a storage device by using the Download application of ODS.
Important: When a program is downloaded from ODS to the control, it is
automatically inserted into the Main program directory on the control
(unless the program is encrypted). An encrypted program is automatically
loaded into the protected directory. See page 5-45. The control
automatically inserts the end of block statements “;” at the end of each line
when the program is downloaded to the control.
To download a part program from ODS to the control’s memory, follow
these steps:
1. Interface the workstation with the control. See page 6-5.
2. Return to the main menu line of ODS.
3. Press
[F3]
to pull down the Application menu.
The workstation displays this screen:
F1 - File F2 - Project F3 - Application F4 - Utility F5 - Configuration
Proj: PALTEST Appl: Upload Util: Get PAL I/O
AMP
PAL
I/O Assignments
Part Program
Upload
Download (A)
(P)
(I)
(R)
(U)
(D)
6.4
Downloading Part Programs
from ODS