Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 158)

Editing Programs On Line
Chapter 5
5-38
To change the program names assigned to the part programs stored in
memory:
1. Press the {PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {RENAME PRGRAM} softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERIFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
3. Key in the current program name or cursor down until the desired
program is in reverse video. Then type in a comma, the new program
name, and press the
{RENAME YES} softkey. To abort the operation,
press the {RENAME NO} softkey.
:current-program-name,new-program-name
RENAME
YES
RENAME
NO
(softkey level 3)
5.6
Renaming Programs
{RENAME PRGRAM}