Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 660)

Paramacros
Chapter 20
20-16
You can use system parameters in any part program, including paramacros
and subprograms. All of these parameters can be used as data or can be
changed by assignment (read and write) unless indicated differently in
Table 20.D. System parameters are generated by the control and can be
modified by operation or programming.
Table 20.D
System Parameters
Parameter # System Parameter Page
2001 to 2732 Dresser/Wheel Offset Tables 20-18
3000 2 Program Stop With Message (PAL) 20-18
3001 System Timer (PAL) 20-19
3002 System Clock 20-19
3003 2 Block Execution Control 1 20-19
3004 2 Block Execution Control 2 20-20
3006 2 Program Stop With Message 20-21
3007 1 Mirror Image 20-22
4001 to 4120 1 Modal Information 20-22
5001 to 5012 1 Coordinates of End Point 20-23
5021 to 5032 1 Coordinates of Commanded Position 20-24
5041 to 5052 1 Machine Coordinate Position 20-24
5061 to 5069 or
5541 to 5552 1 Skip Signal Position (Work Coordinate) 20-25
5071 to 5079 or
5561 to 5572 1 Skip Signal Position (Machine Coordinates) 20-26
5081 to 5089 or
5581 to 5592 1 Active Tool Length Offsets 20-27
5095 to 5096 1 Probe Length and Radius 20-28
5101 to 5112 1 Current Following Error 20-29
5201 to 5212 External Offset amount 20-29
5221 to 5232 G54 Work Coordinate Table Value 20-30
5241 to 5252 G55 Work Coordinate Table Value
5261 to 5272 G56 Work Coordinate Table Value
5281 to 5292 G57 Work Coordinate Table Value
5301 to 5312 G58 Work Coordinate Table Value
5321 to 5332 G59 Work Coordinate Table Value
5341 to 5352 G59.1 Work Coordinate Table Value
5361 to 5372 G59.2 Work Coordinate Table Value
5381 to 5392 G59.3 Work Coordinate Table Value
20.3.3
System Parameters