Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Manual (Page 313)

10 Appendix
10.1.2 Parameters
10-16
Pn50B
Input Signal Selection 2 0000 to FFFF − 8882 After restart Setup −
(cont’d)
Parameter
No.
Name
Setting
Range
Units
Factory
Setting
When
Enabled
Classification Reference
Section
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
/P-CL Signal Mapping
N-OT Signal Mapping
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Reverse run allowed when CN1-13 input signal is ON (L-level).
Reverse run allowed when CN1-7 input signal is ON (L-level).
Reverse run allowed when CN1-8 input signal is ON (L-level).
Reverse run allowed when CN1-9 input signal is ON (L-level) .
Reverse run allowed when CN1-10 input signal is ON (L-level).
Reverse run allowed when CN1-11 input signal is ON (L-level).
Reverse run allowed when CN1-12 input signal is ON (L-level).
Reverse run prohibited.
Reverse run allowed.
Reverse run allowed when CN1-13 input signal is OFF (H-level).
Reverse run allowed when CN1-7 input signal is OFF (H-level).
Reverse run allowed when CN1-8 input signal is OFF (H-level).
Reverse run allowed when CN1-9 input signal is OFF (H-level).
Reverse run allowed when CN1-10 input signal is OFF (H-level).
Reverse run allowed when CN1-11 input signal is OFF (H-level).
Reverse run allowed when CN1-12 input signal is OFF (H-level).
0 to F
/N-CL Signal Mapping
Reserved (Do not change.)
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
ON when CN1-13 input signal is ON (L-level)
ON when CN1-7 input signal is ON (L-level)
ON when CN1-8 input signal is ON (L-level)
ON when CN1-9 input signal is ON (L-level)
ON when CN1-10 input signal is ON (L-level)
ON when CN1-11 input signal is ON (L-level)
ON when CN1-12 input signal is ON (L-level)
Sets signal ON.
Sets signal OFF.
OFF when CN1-13 input signal is OFF (H-level)
OFF when CN1-7 input signal is OFF (H-level)
OFF when CN1-8 input signal is OFF (H-level)
OFF when CN1-9 input signal is OFF (H-level)
OFF when CN1-10 input signal is OFF (H-level)
OFF when CN1-11 input signal is OFF (H-level)
OFF when CN1-12 input signal is OFF (H-level)
Same as /P-CL signal mapping
(Refer to 4.2.3)