Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Manual (Page 39)

2 Panel Display and Operation of Digital Operator
2.1.1 Status Display
2-2
2.1 Panel Display
The servo status can be checked on the panel display of the SERVOPACK.
Also, if an alarm or warning occurs, its alarm or warning number is displayed.
2.1.1 Status Display
The display shows the following status.
2.1.2 Alarm and Warning Display
If an alarm or warning occurs, the display will change in the following order.
Example: Alarm A.E60
2.1.3 Hard Wire Base Block Display
If a hard wire base block (HWBB) occurs, the display will change in the following order.
2.1.4 Displays during Overtravel
The display will change as shown below during overtravel.
Display Meaning
Rotation Detection (/TGON)
Lights if motor speed exceeds the value set in Pn502. (Factory setting: 20 min
-1 )
Base Block
Lights for base block.
Reference Input
Lights when a reference is being input.
Command Option Module Communications Status Display
Lights when communications with the command option module are normal.
Status
Display
Unlit Unlit Unlit Unlit Unlit
Status
Display
Unlit Unlit Unlit Unlit
Forward run prohibited (P-OT signal input ON):
Reverse run prohibited (N-OT signal input ON):
Forward/reverse run prohibited (P-OT/N-OT signal input ON):
Status
Display
Status
Display
Status
Display