Yaskawa Sigma-5 User Manual: Design and Maintenance - Rotary Motors - Manual (Page 316)

10.1 List of Parameters
10-19
Appendix
Pn511
Input Signal Selection 5 0000 to FFFF − 6543 After restart Setup −
(cont’d)
Parameter
No.
Name
Setting
Range
Units
Factory
Setting When Enabled Classification
Refer-
ence
Section
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
Same as /SI4 signal mapping.
Input Signal 5 Mapping for Command Option Module (/SI5)
Input Signal 3 Mapping for Command Option Module (/SI3)
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
Inputs the signal from CN1-13 input terminal.
Inputs the signal from CN1-7 input terminal.
Inputs the signal from CN1-8 input terminal.
Inputs the signal from CN1-9 input terminal.
Inputs the signal from CN1-10 input terminal.
Inputs the signal from CN1-11 input terminal.
Inputs the signal from CN1-12 input terminal.
Sets signal ON.
Sets signal OFF.
Inputs the reverse signal from CN1-13 input terminal.
Inputs the reverse signal from CN1-7 input terminal.
Inputs the reverse signal from CN1-8 input terminal.
Inputs the reverse signal from CN1-9 input terminal.
Inputs the reverse signal from CN1-10 input terminal.
Inputs the reverse signal from CN1-11 input terminal.
Inputs the reverse signal from CN1-12 input terminal.
Input Signal 4 Mapping for Command Option Module (/SI4)
4
5
6
7
8
D
E
F
Inputs the signal from CN1-10 input terminal.
Inputs the signal from CN1-11 input terminal.
Inputs the signal from CN1-12 input terminal.
Sets signal ON.
Sets signal OFF.
Inputs the reverse signal from CN1-10 input terminal.
Inputs the reverse signal from CN1-11 input terminal.
Inputs the reverse signal from CN1-12 input terminal.
Sets signal OFF.
Same as /SI4 signal mapping.
Input Signal 6 Mapping for Command Option Module (/SI6)
0 to 3
9 to F
0 to F
0 to F