PLANET SGSD-1022 - Manual (Page 533)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor system-priority 3
Console(config-if)#
lacp admin-key (Ethernet Interface)
This command configures a port's LACP administration key. Use the no form to
restore the Default Setting .
Syntax
lacp {actor | partner} admin-key key
[no] lacp {actor | partner} admin-key
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
key - The port admin key must be set to the same value for ports that belong to the same link aggregation group (LAG).
(Range: 0-65535)
Default Setting
0
Command Mode
Interface Configuration (Ethernet)
Command Usage
Ports are only allowed to join the same LAG if (1) the LACP system priority matches, (2) the LACP port admin key
matches, and (3) the LACP port channel key matches (if configured).
If the port channel admin key (lacp admin key - Port Channel) is not set when a channel group is formed (i.e., it has the
null value of 0), this key is set to the same value as the port admin key (lacp admin key - Ethernet Interface) used by the
interfaces that joined the group.
Once the remote side of a link has been established, LACP operational settings are already in use on that side.
Configuring LACP settings for the partner only applies to its administrative state, not its operational state, and will only
take effect the next time an aggregate link is established with the partner.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor admin-key 120
Console(config-if)#
533