PLANET SGSD-1022 - Manual (Page 637)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
show map access-list
This command shows the CoS queue mapped to an ACL for the current interface.
Syntax
show map access-list {ip | mac} [interface]
ip - Specifies IP ACLs.
mac - Specifies MAC ACLs.
interface
-ethernet unit/port
-unit - This is device 1.
-port - Port number.
Command Mode
Privileged Exec
Example
Console#show map access-list ip
Eth 1/1
access-list ip aclname cos 3
Console#
5.24 Quality of Service Commands
The commands described in this section are used to configure Differentiated Services (DiffServ) classification criteria and
service policies. You can classify traffic based on access lists, IP Precedence or DSCP values, or VLANs. Using access lists
allows you select traffic based on Layer 2, Layer 3, or Layer 4 information contained in each packet.
Command Function Mode
class-map Creates a class map for a type of traffic GC
match Defines the criteria used to classify traffic CM
policy-map Creates a policy map for multiple interfaces GC
class Defines a traffic classification for the policy to act on PM
set Classifies IP traffic by setting a CoS, DSCP value in a packet PM-C
police Defines an enforcer for classified traffic PM-C
service-policy Applies a policy map defined by the policy-map command to the
input of a particular interface
IC
show class-map Displays the QoS class maps which define matching criteria
used for classifying traffic
PE
637