PLANET SGSD-1022 - Manual (Page 572)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
5.21.2 Editing VLAN Groups
Command Function Mode
vlan database Enters VLAN database mode to add, change, and delete
VLANs
GC
vlan Configures a VLAN, including VID, name and state VC
Table 5-68 Editing VLAN Groups
vlan database
This command enters VLAN database mode. All commands in this mode will take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
Use the VLAN database Command Mode to add, change, and delete VLANs. After finishing configuration changes, you
can display the VLAN settings by entering the show vlan command.
Use the interface vlan Command Mode to define the port membership mode and add or remove ports from a VLAN. The
results of these commands are written to the running-configuration file, and you can display this file by entering the show
running-config command.
Example
Console(config)#vlan database
Console(config-vlan)#
Related Commands
show vlan
vlan
This command configures a VLAN. Use the no form to restore the Default Setting s or delete a VLAN.
Syntax
vlan vlan-id [name vlan-name] media ethernet [state {active | suspend}]
no vlan vlan-id [name | state]
vlan-id -ID of configured VLAN. (Range: 1-4094, no leading zeroes)
572