PLANET SGSD-1022 - Manual (Page 59)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
4.2.4 IP Configuration
This section describes how to configure an IP interface for management access over the network. The IP address for the stack
is obtained via DHCP by default. To manually configure an address, you need to change the Managed Switch’s default settings
to values that are compatible with your network. You may also need to an establish a default gateway between the stack and
management stations that exist on another network segment.
You can manually configure a specific IP address, or direct the device to obtain an address from a BOOTP or DHCP server.
Valid IP addresses consist of four decimal numbers, 0 to 255, separated by periods.
Figure 4-2-4 IP Configuration screenshot
Object Description
• Management VLAN ID of the configured VLAN (1-4094). This is the only VLAN through which you
can manage the Managed Switch.
By default, all ports on the Managed Switch are members of VLAN 1. However,
the management station can be attached to a port belonging to any VLAN, as
long as that VLAN has been assigned an IP address.
• IP Address Mode Specifies whether IP functionality is enabled via :
„ Static - manual configuration
„ DHCP - Dynamic Host Configuration Protocol
„ BOOTP - Boot Protocol
If DHCP/BOOTP is enabled, IP will not function until a reply has been received
from the server. Requests will be broadcast periodically by the switch for an IP
address. (DHCP/BOOTP values can include the IP address, subnet mask, and
default gateway.)
• IP Address Address of the VLAN interface that is allowed management access. Valid IP
addresses consist of four numbers, 0 to 255, separated by periods.
(Default: 192.168.0.100)
59