PLANET SGSD-1022 - Manual (Page 386)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
local -Selects local password checking. Authentication is based on the user name specified with the username command.
Default Setting
login local
Command Mode
Line Configuration
Command Usage
There are three authentication modes provided by the switch itself at login: -login selects authentication by a single global
password as specified by the password line configuration command. When using this method, the management interface
starts in Normal Exec (NE) mode. -login local selects authentication via the user name and password specified by the
username command (i.e., default setting). When using this method, the management interface starts in Normal Exec (NE)
or Privileged Exec (PE) mode, depending on the user’s privilege level (0 or 15 respectively).
no login selects no authentication. When using this method, the management interface starts in Normal Exec (NE) mode.
This command controls login authentication via the switch itself. To configure user names and passwords for remote
authentication servers, you must use the RADIUS or TACACS software installed on those servers.
Example
Console(config-line)#login local
Console(config-line)#
Related Commands
username
password
password
This command specifies the password for a line. Use the no form to remove the password.
Syntax
password {0 | 7} password
no password
{0 | 7} - 0 means plain password, 7 means encrypted password
password - Character string that specifies the line password. (Maximum length: 8 characters plain text, 32 encrypted,
case sensitive)
Default Setting
No password is specified.
Command Mode
Line Configuration
Command Usage
When a connection is started on a line with password protection, the system prompts for the password. If you enter the
correct password, the system shows a prompt. You can use the password-thresh command to set the number of times a
386