PLANET SGSD-1022 - Manual (Page 651)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Console#
5.25.2 IGMP Query Commands (Layer 2)
This section describes commands used to configure Layer 2 IGMP query on the switch.
Command Function Mode
ip igmp snooping querier Allows this device to act as the querier for IGMP snooping GC
ip igmp snooping query-count Configures the query count GC
ip igmp snoopingquery-interval Configures the query interval GC
ip igmp
snoopingquery-max-response-ti
me
Configures the report delay GC
ip igmp
snoopingrouter-port-expire-time
Configures the query timeout GC
Table 5-86 IGMP Query Commands (Layer 2)
ip igmp snooping querier
This command enables the switch as an IGMP querier. Use the no form to disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
IGMP snooping querier is not supported for IGMPv3 snooping (see ip igmp snooping version, page 4-300).
If enabled, the switch will serve as querier if elected. The querier is responsible for asking hosts if they want to receive
multicast traffic.
Example
Console(config)#ip igmp snooping querier
Console(config)#
ip igmp snooping query-count
This command configures the query count. Use the no form to restore the default.
651