PLANET SGSD-1022 - Manual (Page 321)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
4.11.14 IP Filter
You can create a list of up to 16 IP addresses or IP address groups that are allowed management access to the Managed
Switch through the web interface, SNMP, or Telnet.
Command Usage
• The management interfaces are open to all IP addresses by default. Once you add an entry to a filter list, access to that
interface is restricted to the specified addresses.
• If anyone tries to access a management interface on the switch from an invalid address, the switch will reject the connection,
enter an event message in the system log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access respectively. Each of these groups can include up to five
different sets of addresses, either individual addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or Telnet), the switch will not accept overlapping address
ranges. When entering addresses for different groups, the switch will accept overlapping address ranges.
• You cannot delete an individual address from a specified range. You must delete the entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or by specifying both the start address and end
address.
4.11.14.1 Web IP Filter
You can create IP address groups that are allowed management access to the Managed Switch through the Web interface.
Figure 4-11-42 IP Filter page screenshot
321