PLANET SGSD-1022 - Manual (Page 419)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands
snmp-server enable traps
snmp-server enable traps
This command enables this device to send Simple Network Management Protocol traps or informs (i.e., SNMP notifications).
Use the no form to disable SNMP notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
authentication - Keyword to issue authentication failure notifications.
link-up-down - Keyword to issue link-up or link-down notifications.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
If you do not enter an snmp-server enable traps command, no notifications controlled by this command are sent. In order
to configure this device to send SNMP notifications, you must enter at least one snmp-server enable traps command. If
you enter the command with no keywords, both authentication and link-up-down notifications are enabled. If you enter the
command with a keyword, only the notification type related to that keyword is enabled.
The snmp-server enable traps command is used in conjunction with the snmp-server host command. Use the
snmp-server host command to specify which host or hosts receive SNMP notifications. In order to send notifications, you
must configure at least one snmp-server host command.
The authentication, link-up, and link-down traps are legacy notifications, and therefore when used for SNMP Version 3
hosts, they must be enabled in conjunction with the corresponding entries in the Notify View assigned by the snmp-server
group command (page 4-79).
Example
Console(config)#snmp-server enable traps link-up-down
Console(config)#
Related Commands
snmp-server host
419