PLANET SGSD-1022 - Manual (Page 388)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
silent-time
exec-timeout
exec-timeout
This command sets the interval that the system waits until user input is detected. Use the no form to restore the default.
Syntax
exec-timeout [seconds] no exec-timeout
seconds - Integer that specifies the number of seconds.
(Range: 0-65535 seconds; 0: no timeout)
Default Setting
CLI: No timeout
Telnet: 10 minutes
Command Mode
Line Configuration
Command Usage
If user input is detected within the timeout interval, the session is kept open; otherwise the session is terminated.
This command applies to both the local console and Telnet connections.
The timeout for Telnet cannot be disabled.
Using the command without specifying a timeout restores the default setting.
Example
To set the timeout to two minutes, enter this command:
Console(config-line)#exec-timeout 120
Console(config-line)#
Related Commands
silent-time
timeout login response
password-thresh
This command sets the password intrusion threshold which limits the number of failed logon attempts. Use the no form to
remove the threshold value.
Syntax
password-thresh [threshold]
no password-thresh
threshold - The number of allowed password attempts.
(Range: 1-120; 0: no threshold)
Default Setting
The default value is three attempts.
388