PLANET SGSD-1022 - Manual (Page 654)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Global Configuration
Command Usage
The switch must use IGMPv2 or v3 snooping for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Related Commands
ip igmp snooping version
5.25.3 Static Multicast Routing Commands
This section describes commands used to configure static multicast routing on the switch.
Command Function Mode
ip igmp snooping vlan mrouter Adds a multicast router port GC
show ip igmp snooping mrouter Shows multicast router ports PE
Table 5-87 Static Multicast Routing Commands
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id -VLAN ID (Range: 1-4094)
interface
ethernet unit/port
-unit - Stack unit. (Range: 1)
-port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
No static multicast router ports are configured.
654