PLANET SGSD-1022 - Manual (Page 346)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
You can open up to four sessions to the device via Telnet.
5.2 Entering Commands
This section describes how to enter CLI commands.
5.2.1 Keywords and Arguments
A CLI command is a series of keywords and arguments. Keywords identify a command, and arguments specify configuration
parameters. For example, in the command “show interfaces status ethernet 1/5,” show interfaces and status are keywords,
ethernet is an argument that specifies the interface type, and 1/5 specifies the unit/port.
You can enter commands as follows:
To enter a simple command, enter the command keyword.
To enter multiple commands, enter each command in the required order. For example, to enable Privileged Exec Command
Mode, and display the startup configuration, enter:
Console>enable
Console# show startup-config
• To enter commands that require parameters, enter the required parameters after the command keyword. For example, to set a
password for the administrator, enter:
Console(config)# username admin password 0 smith
5.2.2 Minimum Abbreviation
The CLI will accept a minimum number of characters that uniquely identify a command. For example, the command “configure”
can be entered as con. If an entry is ambiguous, the system will prompt for further input.
5.2.3 Command Completion
If you terminate input with a Tab key, the CLI will print the remaining characters of a partial keyword up to the point of ambiguity.
In the “logging history” example, typing log followed by a tab will result in printing the command up to “logging.”
5.2.4 Getting Help on Commands
You can display a brief description of the help system by entering the help command. You can also display command syntax by
346