PLANET SGSD-1022 - Manual (Page 474)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
snmp-client -Adds IP address(es) to the SNMP group.
telnet-client -Adds IP address(es) to the Telnet group.
start-address - A single IP address, or the starting address of a range.
end-address -The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
• If anyone tries to access a management interface on the switch from an invalid address, the switch will reject the
connection, enter an event message in the system log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access respectively. Each of these groups can include up to
five different sets of addresses, either individual addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or Telnet), the switch will not accept overlapping
address ranges. When entering addresses for different groups, the switch will accept overlapping address ranges.
• You cannot delete an individual address from a specified range. You must delete the entire range, and reenter the
addresses.
• You can delete an address range just by specifying the start address, or by specifying both the start address and end
address.
Example
This Example restricts management access to the indicated addresses.
Console(config)#management all-client 192.168.1.19
Console(config)#management all-client 192.168.1.25 192.168.1.30
Console(config)#
show management
This command displays the client IP addresses that are allowed management access to the switch through various protocols.
Syntax
show management {all-client | http-client | snmp-client | telnet-client}
all-client -Adds IP address(es) to the SNMP, web and Telnet groups.
http-client -Adds IP address(es) to the web group.
snmp-client -Adds IP address(es) to the SNMP group.
telnet-client -Adds IP address(es) to the Telnet group.
Command Mode
Privileged Exec
474